![]() ![]() This releases chemicals when heated, and you may pull these chemicals into your lungs when smoking cannabis from a geeb. However, you must be aware that the plastic bottles you used to make your gravity bong contain PET. There you go! Now you know how to make a geeb with basic home supplies. Geebs are certainly not for the faint of heart, and an inexperienced cannabis smoker may want to stay away from this device until they have fully mastered the smoking basics. In such cases, prepare a glass of cold water beforehand. You may cough a bit more than you normally do since gravity bongs can collect more smoke than a traditional water pipe. If you don’t want to finish the entire bottle at once, continue holding it in the water and put the cap back on top to trap the smoke. This creates an effect that will force the smoke to go up into your lungs. This time, gently push the bottle back down into the water. ![]() Now that the bottle is full of smoke, remove the cap and place your mouth over the bottle opening. ![]() Also, check the bottle to ensure there are no holes or gaps in the side. In case your geeb is not filling with smoke, you have to make sure your cap is correctly screwed on. Slowly pull the smaller bottle upwards out of the water. You will see how the bottle fills with smoke. While the bottle remains submerged in the water, use a lighter or hemp wick to ignite your herb. Then, take the cap and carefully screw your bowl back onto the bottle. Hold the smaller bottler in one hand and push it down into the water. If you are not sure which are the best strains to smoke, we recommend you choose one of the best hemp flowers to smoke. Pack your bowl with a pinch of your favorite strain. Next, use the toothpick to poke about 3-5 holes in the foil. Then, place the aluminum foil on the cap and wrap it, creating a small “bowl” for your cannabis. It should be big enough to allow the downstem to fit, and it has to be as airtight as possible.Īlternatively, you can make your own bowl by simply taking a square piece of foil and folding it in half to give it thickness. For this purpose, take the cap of the smaller bottle and use the box cutter to make a hole in it. First, you can use a downstem and bowl, just like in a regular rig. Don’t fill it all the way to the top, since you will have to push the smaller bottle into the water. This last step also applies if you are using a bucket. Take your 2-liter bottle and cut the top of it. ![]() If the top half of the bottle is larger than the bottom half, the hit you receive will be much stronger. Use your knife or box cutter to remove the bottom of your smaller bottle.
0 Comments
Leave a Reply. |